Date 3/21/2003

DERBY OWNERS CLUB

DBA ENCLOSURE MOUNTING INSTRUCTION

1. Remove back on satellite and set aside.

2. Turn game on its side. Make sure right side is facing up

3. Place DBA enclosure on side and align front edge. Align sloping top to the "O" of the word Owners on side decal. (Use inside top edge of the letter "O".)

4. Open DBA enclosure and use a Marker to mark the two holes inside at the top of tower.

5. Locate and mark front and back square hole in middle row. Also Mark top oval hole.

6. Place plastic bag that covered the satellite inside the satellite to catch metal flakes during drilling. Carefully remove bag when drilling in completed.

7. Set enclosure aside. Use center punch on marks and drill a 3/8" hole at each mark. On the oval mark use 3/4" chassis punch to increase size on hole.

8. Install rubber grommet in 3/4" hole. 9. Locate hardware kit and DBA wire harness inside DBA enclosures. Only four enclosures have hardware. But there is enough hardware for eight satellites.

10. Locate the DBA harness. Use Molex pin push and remove the three wires from the AC connector. Cut off the six pin connector that has two wires in it. Push harness through grommet.

11. Align enclosure over holes. Locate bolt and fender washers. From inside satellite, place bolts and fender washers with the black washers and nuts through the hole to the enclosure. Secure and tighten. Install outside plate to enclosure and secure with six bolts.

12. Enclosure install is complete. Set satellite upright and set aside. Repeat procedure until all satellites are completed.

13. After UL kit is installed in satellite, connect the AC wires in three pin Molex provided.

14. Remove wires from coin switch inside satellite. Cut off connector and match up with the loose wires from enclosure (See Below).

15. Re-install to coin switch.

Table of Parts and Tools Required/Recommended

If additional information needed please call Sega Service (415)701-6580